Description
3.11 Accessories
SIRIUS 3RW52 Soft Starter
52 Equipment Manual, 04/2020, A5E35630451002A/RS-AE/005
3RW5 HMI High Feature (HF)
The 3RW5 HMI High Feature can be used to parameterize, monitor and control
(motor ON / OFF) the 3RW52 soft starter. The 3RW5 HMI High Feature can be installed in
the 3RW52 soft starter or in the control cabinet door or mounted on a wall using accessories.
It can be connected to the SIRIUS Soft Starter ES software (TIA Portal) via the local
interface. The 3RW5 HMI High Feature has a TFT color display, LEDs for the status display,
and function and control keys.
Functions
Ⴠ Language selection
Ⴠ Starting and stopping the motor via control keys
Ⴠ Local interface
Ⴠ Display of error diagnoses as plain-text messages
Ⴠ Display of up to 5 measured values at the same time
Ⴠ Analog output and ON / RUN relay output can be parameterized with the
3RW5 HMI High Feature.
Ⴠ Setting communication parameters of 3RW5 communication modules:
– PROFINET (device name and the IP parameters)
– PROFIBUS (station address)
– Modbus TCP (IP parameters)
– Modbus RTU (station address)
– EtherNet/IP (IP parameters)
Ⴠ Backup of parameterization data on a micro SD card
Ⴠ The display of the device LEDs of the 3RW5 HMI High Feature shows the messages of
the following devices:
– 3RW52 soft starter
– 3RW5 HMI High Feature
– Communication module (if there is one)
Ⴠ Firmware updates can be performed using the 3RW5 HMI High Feature and a
micro SD card for the following devices:
– 3RW52 soft starter
– 3RW5 HMI High Feature
– Communication module (if there is one)
Note the information in chapter Firmware update (Page 22).
To Next Page
Loading...
