Mounting and dismantling
3.4 Installing / mounting / removing 3RW5 HMI
SIRIUS 3RW52 Soft Starter
Manual, 01/2019, A5E35630451002A/RS-AD/004
51
● Remove the protective film from the adhesive tape on the seal and secure the seal on the
rear side of the 3RW5 HMI High Feature
①.
Ensure that the seal does not overlap.
● Place the 3RW5 HMI High Feature in the cutout of the control cabinet door
②.
● Continue to screw the screws into the fixing brackets
③ until they protrude approx. 8 mm
at the front. Fasten the fixing brackets onto the 3RW5 HMI High Feature
④.
● Tighten the 3RW5 HMI High Feature with a tightening torque of 0.3 ... 0.35 Nm
⑤.
Ensure that all of the screw heads are in contact with the fixing bracket.
Ensure that the fixing brackets with marking "002" are used.
To Next Page
Loading...
