Siemens SIRIUS 3RW55 - 7.16 User Account Administration

Setting options
• 3RW5 HMI High Feature
Menu: "Parameters > Soft Starter > Parameter set 1 / 2 / 3 > Stopping mode settings >
Stopping mode"
Access protection to the 3RW5 HMI High Feature is not active or has been reset.
• With SIRIUS Soft Starter ES (TIA Portal) via the local interface on the 3RW5 HMI High Feature
Brief overview: Window "Project Navigation" with current project under created Soft Starter >
"Parameters" > Window "Work area" > "Soft Starter > Parameter set 1 / 2 / 3 > Stopping mode
settings"
• With a 󹪝eldbus via a 3RW5 communication module:
– With SIRIUS Soft Starter ES (TIA Portal) Premium / Professional (only via a 3RW5 PROFINET
or PROFIBUS communication module)
Brief overview: See SIRIUS Soft Starter ES (TIA Portal) via the local interface on the
3RW5 HMI High Feature
– Con󹪝guration software of the control system (e.g. STEP 7 with corresponding HSP)
– User program
You can 󹪝nd additional information on the parameters that can be set via the 󹪝eldbus in the
manual of the respective 3RW5 communication module.
Stopping modes of the 3RW55 and 3RW55 Failsafe soft starters
• Coasting down (Page 148)
(Factory setting)
• Voltage ramp (Page 149)
• Torque control (Page 150)
• Pump stop (Page 152)
• DC braking with external braking contactors (Page 154)
This stopping mode is not available for the 3RW55 Failsafe soft starter.
• Dynamic DC braking without contactor (Page 157)
This stopping mode is not available for the 3RW55 Failsafe soft starter.
• Reversing DC braking with a reversing contactor assembly (Page 160)
This stopping mode is not available for the 3RW55 Failsafe soft starter.
• Alternative stopping (Page 163)
Functions
8.2 Run-down
SIRIUS 3RW55 and 3RW55 Failsafe Soft Starters
Equipment Manual, 02/2022, A5E35630887002A/RS-AF/006 147