IO-Link 3SU14
12.2 Electronic modules for ID key-operated switches
SIRIUS ACT 3SU1 pushbuttons and signaling devices
System Manual, 08/2018, A5E03457306020A/RS-AK/010
331
"Delete individual ID key" parameter
To delete an individually encodable ID key from the key list, the following steps are required.
● Use individually encodable ID key in the ID key-operated switches
● Wait for detection of the ID key
● Write the system command "Delete individual ID key" (value 0xA5 in data set (index) 2 -
system commands or button in the Port Configuration Tool
S7-PCT
)
● Check: Status of the individually encodable ID key (data set (index) 92 - diagnostics)
● Remove the ID key from the ID key-operated switch
Delete individual ID key used in the ID key-operated switch.
Status of the individually encodable ID key (data set (index) 92 - diagnostics, byte
19.0 ... 19.7)
You will find additional information in Chapter "Data set (index) 92 - diagnostics (Page 583)".
Individually encodable ID key detected.
No valid individually encodable ID key used.
3 Deleted ID key not in the memory of the electronic module.
To Next Page
Loading...
