Siemens SITOP DC-UPS-Module 40

© Siemens AG 2016 8 of 8 SITOP DC USV Modul 40
A5E38473872, 08.2016
Vorschriften / Standards:
ATEX
II 3G Ex nA nC IIC T4 Gc
Harzardous Areas: An enclosure / cabinet rated min. IP54 must be provided in the final installation.
The enclosure / cabinet must be in accordance with the requirement of EN 60079-0:2009 and/or EN60079-15:2010
DIP switches shall not be used in operation or while a hazardous area may be present
The USB-interface cable has to be secured according to the requirements of EN 60079-15:2010, otherwise a permanent connection / disconnection
or operation is not permitted while hazardous area conditions may be present.
Without meeting the requirements of EN 60079-15:2010, the USB-cable is permitted for installation / maintenance only.
WARNUNG
ANSCHLÜSSE NUR IN NICHT-EXPLOSIVER UMGEBUNG TRENNEN!
SCHALTERBETÄTIGUNG NUR IN NICHT-EXPLOSIVER UMGEBUNG DURCHFÜHREN!
Der Signalstecker darf in Ex Bereichen nur mit zusätzlicher Befestigungen verwendet werden um der EN 60079-15 zu genügen.
WARNING
SEPARATE TERMINALS IN NON-HAZARDOUS AREAL ONLY!
ACTUATE SWITCHES IN NON-HAZARDOUS AREAS ONLY!
The signal plug must not be used without additional fixings in explosive atmospheres to fulfill the requirements according EN 60079-15.
© Siemens AG Österreich, AT-1210 Vienna, Austria. All rights reserved.
Liefermöglichkeiten und technische Änderungen vorbehalten
Availability and technical specifications subject to change without prior notice