Siemens SITOP PSU8600 - Page 11

Table of contents
Power supply system SITOP PSU8600
Manual, 09.2018, A5E36758446-5-76
11
7.8.6 Parameters of the SITOP PSU8600 in the OPC UA client ................................................... 314
7.8.6.1 ActualBufferState .................................................................................................................. 315
7.8.6.2 ActualState ............................................................................................................................ 315
7.8.6.3 ActualUpdateState ................................................................................................................ 316
7.8.6.4 Alarm ..................................................................................................................................... 316
7.8.6.5 Buffering ................................................................................................................................ 321
7.8.6.6 General ................................................................................................................................. 321
7.8.6.7 Hardware .............................................................................................................................. 322
7.8.6.8 Identification .......................................................................................................................... 322
7.8.6.9 Lock....................................................................................................................................... 323
7.8.6.10 MethodSet ............................................................................................................................. 323
7.8.6.11 Network ................................................................................................................................. 324
7.8.6.12 NTP client ............................................................................................................................. 324
7.8.6.13 NTP client status ................................................................................................................... 324
7.8.6.14 OPC UA Server ..................................................................................................................... 325
7.8.6.15 Outputs ................................................................................................................................. 325
7.8.6.16 ParameterSet ........................................................................................................................
327
7.8.6.17 PROFINET ............................................................................................................................ 327
7.8.6.18 PROFIenergy ........................................................................................................................ 327
7.8.6.19 SubDevices ........................................................................................................................... 328
7.8.6.20 User management ................................................................................................................ 344
7.8.6.21 Web server ............................................................................................................................ 345
7.8.6.22 Other ..................................................................................................................................... 345
7.8.7 OPC UA - performance ......................................................................................................... 346
7.8.8 Recommissioning after a basic device has been replaced - or after restoring the
factory settings ...................................................................................................................... 346
7.9 NTP client ............................................................................................................................. 347
7.10 Parameter write behavior of the SITOP PSU8600 ............................................................... 348
7.10.1 writing data in the STOP or RUN mode via PROFINET ....................................................... 348
7.10.2 Retentively saved PROFINET data sets in the RUN mode .................................................. 350
7.10.3 OPC UA data sets that are always retentively saved ........................................................... 353
7.11 Identification data for PROFINET IO .................................................................................... 354
7.12 SITOP Manager .................................................................................................................... 355
7.12.1 SITOP Manager introduction ................................................................................................ 355
7.12.2 System overview ................................................................................................................... 355
7.12.3
Components .......................................................................................................................... 356
8 Troubleshooting .................................................................................................................................. 357
8.1 Troubleshooting based on the LED signal sequence ........................................................... 357
8.2 PROFINET alarm list ............................................................................................................ 357
8.3 Alarm list web server ............................................................................................................. 364
9 Technical data .................................................................................................................................... 383
9.1 Input data .............................................................................................................................. 383
9.2 Output data ........................................................................................................................... 385
9.3 Efficiency ............................................................................................................................... 392
9.4 Closed-loop control ............................................................................................................... 394