Siemens SITOP series - Connecting the Trends of the Faceplate with Data Sources

Working with the library
7.3 WinCC Comfort/Advanced
SITOP PSU8600 Firmware V1.4: Faceplates and Communication Blocks V2.4 for SIMATIC STEP 7 V14 SP1, V15 and V15.1 (TIA)
118 Function Manual, 11.2018, A5E37763954-09-76
7.3.3
Connecting the trends of the faceplate with data sources
Introduction
Connect the trends to the data sources of the individual outputs. This graphically displays the
power consumption of the individual outputs over time.
Connecting the trends for the PSU8600 main module
Follow these steps to connect the trends for the PSU8600 main module:
Table 7- 7
Step number
Instruction
1
In the "Project tree", select and open the screen with your faceplate.
2 Select the screen and go to the "Properties > Interface" tab.
3 Double click to open the settings for the trends of the PSU8600 main module.