Working with the library
7.3 WinCC Comfort/Advanced
SITOP PSU8600 Firmware V1.4: Faceplates and Communication Blocks V2.4 for SIMATIC STEP 7 V14 SP1, V15 and V15.1 (TIA)
Function Manual, 11.2018, A5E37763954-09-76
125
Configuring the alarms display call
Follow these steps to configure the alarm display call:
Table 7- 10
1 In the "Project tree", navigate to the "Tag table_1200_Comfort".
2
• Select your HMI connection for both the tags.
• Use the acquisition mode "Cyclic continuous" for both the tags.
• From the Global Transfer DB of the "UDT_PSU8600_Data" block, select the control tag "AlarmHistory"
as the first and "AlarmPending" as the second tag.
To Next Page
Loading...
