Siemens SITOP series - Status Displays and Signaling

SITOP PSU8600 Firmware V1.4: Faceplates and Communication Blocks V2.4 for SIMATIC STEP 7 V14 SP1, V15 and V15.1 (TIA)
Function Manual, 11.2018, A5E37763954-09-76
13
Hardware and software requirements
4
Hardware requirements
Table 4- 1
Component
Article number
No. of compo-
nents required
Alternative
S7-1516
6ES7516-3AN00-0AB0
1
Other S7-1200 or S7-1500
Comfort Panel TP1200
Comfort
6AV2124-0MC01-0AX0 1 Other Comfort Panels
SITOP PSU8600 6EP3437-8MB00-2CY0 1 Alternatively, you can also use:
6EP3436-8MB00-2CY0
6EP3436-8SB00-2AY0
6EP3437-8MB00-2CY0
6EP3437-8SB00-2AY0
SITOP CNX8600 6EP4437-8XB00-0CY0 4 Optional
Alternatively, you can also use:
SITOP CNX8600 (4 x 5 A).
6EP4436-8XB00-0CY0
SITOP CNX8600 (8 x 2.5 A).
6EP4436-8XB00-0DY0
SITOP BUF8600
(100 ms/40 A)
6EP4297-8HB00-0XY0 2 Optional
Alternatively, you can also use
SITOP BUF8600
(300 ms/40 A).
(6EP4297-8HB10-0XY0) or
SITOP BUF8600 (4 s/40 A).
(6EP4293-8HB00-0XY0) or
SITOP BUF8600 (10 s/40 A).
(6EP4295-8HB00-0XY0).
SITOP UPS8600 6EP4197-8AB00-0XY0 2 Either two BUF8600 only or two
UPS8600 only or one BUF8600
and one UPS8600 can be add-
ed to PSU8600.
SITOP BAT8600
LiFePO4
6EP4143-8JB00-0XY0 5 Five BAT8600 LiFePO4 can be
added to UPS8600. Alternative-
ly you can use BAT8600 Pb
battery. All the batteries
plugged should be of the same
type.
Third-party battery 1 Only one battery can be con-
nected to UPS8600.