Siemens SITOP series - Change-over Switch Functions

Hardware and software requirements
SITOP PSU8600 Firmware V1.4: Faceplates and Communication Blocks V2.4 for SIMATIC STEP 7 V14 SP1, V15 and V15.1 (TIA)
14 Function Manual, 11.2018, A5E37763954-09-76
Software requirements
Table 4- 2
Component
Article number
Number
WinCC Comfort (for configuring Comfort
Panels)
6AV2101-0AA03-0AA5 Depending on the required
target system.
WinCC Advanced (for configuring WinCC
Runtime Advanced)
WinCC Runtime Advanced
6AV2102-0AA03-0AA5
6AV2104- ... 3-0
WinCC Professional (for configuring WinCC
Runtime Professional)
WinCC Runtime Professional
6AV2105- ... 3-0
SIMATIC STEP 7 V15.1/V15 and V14 SP1
6ES7822-1...03-...