Installing and configuring the SITOP UPS1600 in STEP 7 V12
SITOP UPS1600 under STEP 7 V12
22 Getting Started,
Integrating the SITOP UPS1100 battery module
1. Ensure that you are in the device view.
2. Navigate to below the task card "Hardware catalog" in the palette "Catalog" to the
required UPS1100 battery module.
3. Click on the UPS1100 and drag it to the free rack location next to the UPS1600 and drop
it.
4. To subsequently configure the module type and number of modules, click on the
UPS1600 and in the inspector window, on the "Properties" and "General" tab.
5. Click on the symbol to open the "Device configuration" and select "Energy storage.
6. Check whether the "SITOP UPS 1100 battery" option field is activated. Activate it if it is
deactivated.
To Next Page
Loading...
