3.3 Closing the device
① Cover over buttons ⑤ Blanking plug
② Cable gland ⑥ Safety catch (front)
③ Safety catch (back) ⑦ Cover (front)
④ Cover (rear) for electrical terminal compartment
Figure3-3 View of the pressure transmitter: Left: Back right: Front view
1. Screw on the cover ④ and ⑦ as far as it will go.
Make sure that there is no gap between enclosure and cover.
2. Secure each cover with the cover catch ③ and ⑥ by removing the screw.
For the aluminum enclosure, observe the torque (Page43).
3. Close the cover over the buttons①.
4. Tighten the screw for the cover over the buttons.
Connecting
3.3Closing the device
SITRANS P320/P420
12 Service Manual, 11/2023, A5E44914141-AC
To Next Page
Loading...
