Siemens SITRANS 7MF03.0 - 5.1.1 Ordering transmitter electronics

Requirement
You have ordered transmitter electronics. (Page22)
• Note that the transmitter electronics are delivered with pre-programmed factory settings. It
is therefore not possible to change certain parameters (e.g. serial number) on site.
Procedure
To replace the transmitter electronics, perform the following work steps:
1. Remove the display.
Removing the display (Page23)
2. Remove the current transmitter electronics.
Removing the transmitter electronics (Page24)
3. Install the new transmitter electronics.
Installing the transmitter electronics (Page26)
4. Install the display.
Installing the display (Page26)
5. Commission the device.
Commissioning the device after transmitter electronics have been replaced (Page27)
5.1.1 Ordering transmitter electronics
Note
The transmitter electronics are only available as a spare part in the "Ex i" version and may be used
with devices without explosion protection.
Procedure
1. Select the article number:
Transmitter electronics Communication
7MF7903-1AB HART
7MF7903-1BB PROFIBUS PA
7MF7903-1CB FOUNDATION Fieldbus
2. Enter the serial number of your device under the order code "Y55".
The serial number (S/N) can be found on the nameplate of the unit.
Replacing spare parts
5.1Replacing the transmitter electronics
SITRANS P320/P420
22 Service Manual, 11/2023, A5E44914141-AC