Procedure
1. Loosen the xing screws of the display support on the left and right.
2. Remove the display support.
3. Carefully pull the transmitter electronics out of the enclosure.
Ensure that the ribbon cable behind the transmitter electronics is not damaged.
Figure5-2 Transmitter electronics: Rear view
4. If present, remove the insulation plate ③.
5. Disconnect the sensor electronics ② of the 6-pin connector ①.
Replacing spare parts
5.1Replacing the transmitter electronics
SITRANS P320/P420
Service Manual, 11/2023, A5E44914141-AC 25
To Next Page
Loading...
