Siemens SITRANS 7MF03.0 - 5.1.4 Installing the transmitter electronics; 5.1.5 Installing the display

5.1.4 Installing the transmitter electronics
Procedure



Figure5-3 Transmitter electronics: Rear view
1. Ensure that the serial number of the replacement electronics matches the serial number of
your device.
Ordering transmitter electronics (Page22)
2. Connect the sensor electronics ② with the 6-pin connector ① of the transmitter electronics.
Ensure that the sensor electronics is correctly inserted.
3. If available, insert the insulation plate ③.
4. Insert the transmitter electronics into the enclosure.
Ensure that the ribbon cables do not kink, pinch or twist.
5. Work in the reverse order to that described in section Removing the transmitter electronics
(Page24).
5.1.5 Installing the display
1. Connect the cable of the display with the 4-pole connector ① by observing the poling:

2. Fasten the display in the holder.
Replacing spare parts
5.1Replacing the transmitter electronics
SITRANS P320/P420
26 Service Manual, 11/2023, A5E44914141-AC