Siemens SITRANS 7MF03.0 - 5.5 Changing nameplates; 5.6 Ordering data for repair parts

5.5 Changing nameplates
1. Order the desired replacement nameplate.
For printed replacement nameplates, enter the serial number of your device under the order
code "Y55".
2. Loosen the locking screw ① a bit.


Figure5-6 Top view
3. Using pliers with cutting edges, carefully pull out the grooved pin ②.
4. Remove the damaged nameplate.
5. Install the replacement nameplate.
6. Carefully press in the supplied new grooved pin ②.
7. Push the replacement nameplate as far as it goes on the locking screw ①.
8. Tighten the locking screw ①.
5.6 Ordering data for repair parts
The ordering data for the repair parts can be found in PIA Life Cycle Portal (Intranet) (https://pia-
portal.automation.siemens.com/default.htm)
Replacing spare parts
5.6Ordering data for repair parts
SITRANS P320/P420
Service Manual, 11/2023, A5E44914141-AC 35