Siemens SITRANS 7MF03.0 - 2 Description; 2.1 Structure

Description
2
2.1 Structure
Depending on the customer-speci󹪝c order, the device comprises di󹪜erent parts.















① Cover over buttons and nameplate with general information ⑨ Locking screw for the cover over the buttons
② Cover with glass pane (optional) ⑩ Cover (rear) for electrical terminal compart‐
ment
③ Display (optional) ⑪ Electrical terminal compartment
④ Safety catch (front) ⑫ Safety catch (back)
⑤ Locking screw for the enclosure ⑬ Ground terminal
⑥ Process connection ⑭ Nameplate with information on the remote
seal
⑦ Nameplate with approval information ⑮ Blanking plug
⑧ Cable inlet, optionally with cable gland  
Figure2-1 Example
• The electronics enclosure is made of die cast aluminum or precision cast stainless steel.
• The housing has a removable cover at the front and the back.
• Depending on the device version, the front cover ② may be designed with a glass pane.
• The cable gland ⑧ to the electrical terminal compartment is at the side; either the left or
right-hand one can be used. The unused opening is closed with a blanking plug ⑮.
• The ground terminal ⑬ is located on the side.
SITRANS P320/P420
Service Manual, 11/2023, A5E44914141-AC 7