SITRANS FM100
A5E48762204-AA page 9
8.2 Pin assignment
8.2.1 External connection with electrical connector M12x1 4-pin for
options C3T0 / Exx0 and Pxx0
8.2.2 Connection Exx0 / Pxx0 sensor
For the remote versions Pxx0 (PVC cable) and Exx0 (ETFE cable), the sensor
and transmitter are delivered ex works with the cable connected.
The on-site installation may require dismantling the cable and reconnecting it
later.
Note:
In principle, the cable can be shortened by the user on the transmitter side and
connected to the transmitter again after appropriate assembly.
Attention!
A customer extension of the connection cable is not recommended because
of the necessary continuous shielding and leads to malfunction of the
device. The cable permanently connected to the sensor must not be
disassembled.
Wiring diagram Transmitter Termination Connection cable
(PVC and ETFE cable)
To Next Page
Loading...
