SITRANS FM100
A5E48762204-AA page 25
Volume flow, temperature and part quantity counter
The simulation starts as soon as the simulation is activated and the setting menu
is exited. The simulation is interrupted or stopped, if the setting menu is called up.
There are 3 different simulation types available for each purpose:
a.) „Triangle“ mode
In "Triangle" mode, the simulation
value increases continuously in the
increment of the parameter
"Increment value" and in the interval
"Interval time" with the "Start value".
After the amount of the parameter
"intervals", the simulation value
decreases again in the same way,
in order to increase again. This
process is repeated continuously until the set time "Sim Auto Stop Time" has
expired and the simulation ends.
b.) "Monotonic" mode
In "Monotonic" mode, the simulation
value increases continuously in the step
size of the parameter "Increment value"
and in the interval "Interval time" with the
"Start value". After the amount of
"Intervals" or the expiration of "Sim Auto
Stop Time", the simulation ends.
c.) “Static” mode
In the "Static" mode, a constant value is output for
the measured values flow and temperature. The
simulation ends after the set simulation time.
In the "static" simulation for the part quantity
counter, the counter is only changed once by the
set "increment value" after the start.
When simulating the subset counter, note that in triangle mode, the submenu
counter must be in bidirectional mode to achieve the expected effect.
Time
Simulation value
Interval time
Start value
Intervals
Increment value
Sim Autostoptime
Time
Simulation value
Interval time
Start value
Intervals
Increment value
Sim Autostoptime
Time
Simulation value
Start
value
Sim Autostoptime
Time
Simulation value
Counter state
before start
Inkrementwert
Sim Autostoptime
To Next Page
Loading...
