Siemens SITRANS F FST030 - Integrating a HART Device in a HART Modem Network

SIMATIC PDM
B.1 Commissioning with SIMATIC PDM
SITRANS F Ultrasonic flowmeters FST030 (HART)
Operating Instructions, 08/2017, A5E35971532-AC
127
B.1.6
Integrating a HART device in a HART modem network
Figure B-1 HART modem
The following describes how to integrate a HART device in a HART modem network.
Requirements
● A project has been created.
● An access point of the computer is set to the COM port to which the HART modem
network is connected.
Integrating a HART device in a HART modem network
1. Open the project in the process device network view.
2. Right-click the "Networks" object in the tree structure. In the shortcut menu that opens,
select the menu command Insert New Object > Communication network. The "Insert
Object(s) - <...>" dialog box opens.
3. Click the "Assign Device Type" button.
The "Insert Object(s) - Assign Device Type" dialog box opens. You can find additional
information in the section "Insert Object - Assign Device Type" dialog box.
4. To set the network properties, select the inserted HART modem network in the right
window and right-click. Select the Object Properties command in the displayed shortcut
menu.