Siemens SITRANS F FST030 - Diagnosing with PDM

SIMATIC PDM
B.2 Diagnosing with PDM
SITRANS F Ultrasonic flowmeters FST030 (HART)
136 Operating Instructions, 08/2017, A5E35971532-AC
B.2
Diagnosing with PDM
SIMATIC PDM is a suitable tool for diagnosing the device.
You can use SIMATIC PDM to read all available parameters to a table for analyzing offline,
view online/actual process values and online/actual diagnostic information.
Requirements
The following procedure must be completed before diagnosing:
● Installation of PDM and PDM device driver
● Connection of HART interface
Refer to Commissioning with SIMATIC PDM (Page 125).
Diagnosing with PDM
Online process values are available under menu View > Process Values.
Online diagnostic information is available under menu View → Device Status.