Operating
7.3 Reading / changing parameters
SITRANS F Ultrasonic flowmeters FST030 (HART)
Operating Instructions, 08/2017, A5E35971532-AC
77
Editable alphanumeric parameters are displayed as shown here.
Table 7- 7 Key functions - editing alphanumeric values
Select the next left position.
If the most left position is selected: exit the parameter edit view without confirming the
changes. Keep pressing the key to jump to the most left position.
Change the selected number/character.
Numeric characters: increase the number by one (for example from 7 to 8)
ASCII characters: select the previous character in the alphabet.
Change the selected number/character.
Numeric characters: decrease the number by one (for example. from 8 to 7)
ASCII characters: select the next character in the alphabet.
Select the next right position.
If most right position is selected: confirm the change and exit the parameter edit view.
Keep pressing the key to jump to the most right position.
Note
Ensure that the new value is within the minimum/maximum range when changing numeric
values.
Note
##### signs in display
The display is unable to show the measured value. Change the measurement units or the
resolution.
To Next Page
Loading...
