Installing/Mounting
4.4 Removing the liner protectors
SITRANS F M MAG 3100
26 Operating Instructions, 06/2010, A5E03005599-01
Sensors with PTFE liner
At delivery the sensor is mounted with wooden blanks to hold the liner in place during
transportation and storage. After only a few hours without the blanks, the liner will creep
back towards its original shape and installation will be more difficult to carry out.
Figure 4-5 Sensor with wooden blanks
● Remove the blanks immediately before mounting the sensor
Figure 4-6 Removing wooden blanks
Sensors with PFA liner
At delivery the sensor is mounted with blanks to protect the liner during transportation and
storage.
Figure 4-7 Sensor with blanks
To Next Page
Loading...
