Siemens SITRANS F M MAG 5000 CT - Local User Interface

Commissioning
6.5 Changing basic settings
SITRANS F M MAG 5000/6000
Operating Instructions, 01/2010, SFIDK.PS.026.G1.02
41
Parameter Description
Empty pipe cut-off When set to "On" the alarm will indicate when sensor is running empty. All
readings, display and outputs, will indicate zero.
Error level Selecting error level at which flowmeter will detect an error.
Note
Totalizer 2 is not visible when batch is selected as digital output.
Note
Q
max
2 is visible only when chosen as external input.
Change basic settings as follows:
1. Press top up key
for 2 sec.
2. Enter password.
3. Use forward key
to reach basic settings menu.
4. Press lock/unlock key
to unlock settings.
5. Use forward key
or backward key to reach relevant menu.
6. Press lock/unlock key
to unlock settings.
7. Use select key
and change key to change settings.
8. Press lock/unlock key
to confirm new settings.
9. Repeat steps 5-8 to change other settings.
10. Press top up key
two times to exit setup mode.
See change basic settings menu diagram (Page 77).
De
cimal point can be positioned and units set individually for flow rate in totalizer 1 and
totalizer 2.
Changing decimal point position
1. Enter the respective totalizer menu.
2. Use select key
to position cursor below decimal point.
3. Use change key
to move decimal point to requested position.
Changing units
1. Use select key to position cursor below unit.
2. Press change key
until requested unit is displayed.