Siemens SITRANS F M MAG 5000 CT - Menu Structure Overview

Commissioning
6.6 Changing operator menu setup
SITRANS F M MAG 5000/6000
42 Operating Instructions, 01/2010, SFIDK.PS.026.G1.02
6.6 Changing operator menu setup
In the operator menu the menus required for daily operation of the flowmeter are shown. It is
possible to hide and change some of the menus in the operator menu. This is done in the
operator menu setup menu, see operator menu setup diagram (Page 78).
Customizing menus in operator menu
To customize the menus in the operator menu perform the following steps:
1. Press top up key
for 2 sec.
2. Enter password.
3. Use forward key
or backward key to reach operator menu.
Changing text in line 1
1. Press lock/unlock key to unlock setting.
2. Use change key
to select desired text.
3. Press lock/unlock key
to confirm selected text.
Note
If "Text" is selected in line 2, this line functions as a heading for the value shown in line 3.
Otherwise it shows the actual value of the reading selected.
Enabling two readings
1. Use forward key to reach requested menu.
2. Press lock/unlock key
to unlock setting.
3. Use select key
to move cursor to upper line.
4. Use change key
to select requested reading.
5. Press lock/unlock key
to confirm selection.
6. Use select key
to move cursor to line 3.
7. Use change key
to select desired setting.
8. Press lock/unlock key
to confirm new setting.
9. Repeat steps 1-8 for each requested menu.
Showing/hiding menus in operator menu
1. Use forward key to reach requested menu.
2. Press lock/unlock key
to unlock setting.
3. Use select key
to move cursor to / symbol.
4. Press change key
to select visible ( ) or hidden ( ).
5. Press lock/unlock key
to confirm new setting.