Installing/Mounting
4.4 Remote installation
MAG 6000 I / MAG 6000 I Ex de transmitter
26 Operating Instructions, 04/2016, A5E02083319-AG
3. Mount SENSORPROM
®
in remote transmitter.
4. Fit M20 or ½" NPT cable glands on sensor terminal box.
5. Fit and connect electrode and coil cables as described in Connecting (Page 31).
Note
Unscreened cable ends must be kept as short as possible.
Electrode cable and coil cable must be kept separate to prevent interference.
6. Tighten cable glands and lid screws well to obtain optimum sealing.
Mount terminal box lid before power up.
To Next Page
Loading...
