Menu diagrams
A.11 Sensor characteristics
MAG 6000 I / MAG 6000 I Ex de transmitter
Operating Instructions, 04/2016, A5E02083319-AG
81
1)
Error status (level
or number) on an output is updated only at the time the error status changes
(occurs or disappears). If P40 is suppressed after it has been detected (at power up), the out-
put does not change state. In this case the power must be switched off/on to suppress the P40
The frequency can be set to 44 Hz in the MAG 6000 SV transmitter only.
To Next Page
Loading...
