The standard MAG 8000 CT format is:
● Europe: m
3
for totalizer and m
3
/h for flow rate
The following MAG 8000 units and combinations are available:
Volume: m
3
, m
3
× 100, L × 100, Gallon, G × 100, G × 1000, MG, CF × 100, CF × 1000, AF,
AI, kl, ML, BBL42
Flow rate: m
3
/min, m
3
/h, m
3
/d, L/s, L/min, L/h, ML/d, GPS, GPM, GPH, GPD, MGD, CFS, CFM,
CFH, BBL42/s, BBL42/min, BBL42/h, BBL42/d
To ensure selection of correct conversion factor, see unit conversion table in appendix
(Page 135).
All measurement units are printed on a label affixed to the display (except the European
version). Some meter sizes have a factor included to secure the 8 digit display value will not
overrun after short time of operation. Manual configuration of new units is allowed. A new
sticker showing the new settings must then be affixed to the display.
Protected parameters
The following parameters are protected (see also parameter lists in appendix (Page 136)):
MAG 8000 Standard / MAG 8000 CT / MAG 8000 Irrigation MAG 8000 CT (additionally)
Parameter no. Parameter name Parameter no. Parameter name
- New password 101 Totalizer 1
5 Sensor tube diameter 102 Totalizer 2
7 Meter No. 303 Operation excitation frequency
8 Totalizer unit 305 Decimal point place
9 Flow unit 310 Flow direction totalizer 1
10 Qn (Q3) 312 Flow direction totalizer 2
300 Totalizer unit factor 327 Adjustment factor
301 Flow unit factor 328 Low flow cut-off
302 Pipe size 332 Empty pipe impedance
321 Calibration date 420 Device Communication Address
323 Calibration factor 550 Coil current active
Flow Tool
A.5 Unit selection
SITRANS MAG 8000
Operating Instructions, 11/2018, A5E03071515-AE 123
To Next Page
Loading...
