8-3
1010PFM-3G
Section 8
Connect to XDCR CH1
terminal on 1010WP
1011TS Transducer
1015AT Xdc
cable ada
ter
Connect XMIT to UP
on 1015AT Adapter
Connect RCV to DN on
1015AT Adapter
1011TS Transduce
Holder
To connect the 1011TS to a 1010P flow computer
Press to enable the Thickness Gauge. This selects the Thickness Gauge main menu. Here you
can proceed to measure the wall thickness or calibrate your thickness gauge transducer.
Use to move the cursor to [Thickness Gauge].
8.4 SELECTING THE THICKNESS GAUGE
Turn on the Meter and press the key.
Next, press the key. Observe the cursor pointing to [Dual Channel Flow].
MENU
ENT
Meter Type >Dual Channel Flow
Meter Facilites Dual Path Flow
Ch 1+2 Flow
Ch 1-2 Flow
Thickness Gauge
Meter Type Dual Channel Flow
Meter Facilites Dual Path Flow
Ch 1+2 Flow
Ch 1-2 Flow
>Thickness Gauge
Measure Thickness
Calibration
To Next Page
Loading...
