8-4
1010PFM-3G
Section 8
8.5 CALIBRATING THE THICKNESS GAUGE
If you purchased the 1011TS thickness transducer separately then calibrate the transducer before
using it to measure a pipe wall. The 1011TS Transducer Holder includes two built-in steel calibration
blocks. One is 0.100” thick and the other is 0.500” thick (see below). You will use these blocks in
conjunction with the Thickness Gauge Calibration menu to calibrate your transducer.
To calibrate the 1011TS transducer, remove it from its holder:
THICKNESS GAUGE
CONTROLOTRON S/N
1011TS
0.100
0.500
0.500
Calibration
Block
0.100
Calibration
Block
Transducer
Holder
Label
0.500
Identification
0.100
Identification
Unscrew the Transducer Holder
Cap (counter-clockwise)
Remove the tensioning
spring
Withdraw the
transducer & cable
from the holder
These should be
connected according to
previous instructions
Transducer Holder
Siemens
To Next Page
Loading...
