6
If you want to redo the Initial Makeup, move cursor to New Makeup, then press the <ENT> key.
This resets the option list. You can now repeat the install routine described previously.
z Refer to the FUP1010 Portable field manual for the Empty Pipe Set procedure.
z Refer to the FUP1010 Portable field manual for the Zero Flow Adjust procedure.
NOTE: For additional FUP1010 flowmeter functions refer to the FUP1010PFM-3 field
manual.
Install Completed? Yes
New Makeup
After the meter completes its Initial Makeup command, the [Installed Completed?] option
list changes to:
To Next Page
Loading...
