1-10
1010PFM-3G
Section 1
1.7 THE 1010P KEYPAD
The 1010P integral keypad provides 32 numeric and function keys (see table below). Use these keys to
enter, review or edit the site data. Certain keys control the graphics display, Datalogger and Totalizer.
“Blind Models,” having no keypad or display, must be set up by using their serial data port.
NOTE: The keypad does not have alphabetic keys. Scrolling lists provide alpha-numeric char-
acters as needed.
1.8 INTRODUCTION TO THE 1010P MENU SCREENS
The figure below shows a typical 1010P menu screen (e.g., Pipe Data Menu).
TYPICAL INSTALLATION MENU SCREEN
Highlighted
Data
Menu cell data
(right-hand column)
Current
Selected Menu
Menu cell
Left-hand column)
Highlighted
Menu cell
Menu Prompt Line
Reverse video)
Current
Selected
Meter Type
Siemens 2 Channel [1] SITE 1
Select Pipe Size 1” type K
Pipe OD <in> 0.500
Pipe Material Steel
Wall Thickness 0.100
Liner Material None
Liner Thickness 0.000
Select Pipe Class Copper Tube Table
Pipe Data
Select Pipe Class from Pipe Table
Current Selected
Measurement
Channel
KEYPAD FUNCTION CHART
MENU Press to activate the Installation Menu.
ENT Press <ENT> to store numeric data, select from option lists, etc.
LEFT, RIGHT ARROWS Menu navigation keys move cursor in respective directions.
UP, DOWN ARROWS Same as <Left> and <Right>. Also scrolls option list and graphic
display screen.
CLR Clear Key for erasing data, or selecting list options.
NUMBERS 0-9 Use to type numeric data.
DECIMAL POINT Use for decimal points in numeric data.
MATH OPERATORS Allows 4-function math operations in numeric entry cells.
“F” KEYS 1-3 Totalizer control and special function keys.
“F4” KEY CAUTION: SYSTEM RESET KEY (during power up)
CTL & ALT Used as shift keys for alternate key functions.
DATALOG Triggers immediate Datalogger report.
PLUS/MINUS [+/-] Changes the sign of numeric data.
KEY USAGE
To Next Page
Loading...
