1-11
1010PFM-3G
Section 1
1.9 HOW TO USE THE INSTALLATION MENU
This section introduces the System 1010P Installation Menu. It explains how to access and leave the
Installation Menu, and how to enter site data. The Installation Menu consists of submenus, each provid-
ing individual menu locations (menu cells) that store site data. For convenience, this manual refers to
sub-menus simply as menus (e.g., the Pipe Data Menu). Shown below is the Clamp-on, Full Site setup
screen for Channel 1 of a dual-channel meter. Single channel systems are identical. For FastStart
setup, refer to paragraph 1-11.
Seimens 2 Channel [1]
Create-Name-Recall-Enable & Delete Site
Pipe Data
Application Data
Pick/Install Xdcr
Operation Adjust
Flow/Total Units
Data Span/Set/Cal
Stripchart Setup
Datalogger Setup
I/O Data Control
Diagnostic Data
Channel Setup
Full Site Setup
EXPLANATION OF THE CALL-OUTS
Menu Prompt Line When you select a menu cell, a highlighted text prompt appears on the top of the
screen to explain the function of the cell.
Current Selected [2 Channel] indicates Dual Channel meter operating mode selected.
Meter Type
Selected Channel The [1] indicates that measurement Channel 1 is currently selected.
Highlighted Menu Cell Highlighting a menu cell switches its left-hand and right-hand columns to being
highlighted (white type on black).
Highlighted Data The right-hand column shows the current value highlighted. Pressing the <Right
Arrow> provides access to an option list or numeric field where you can change the
current value as required.
Menu Cell A menu cell is an individual location within a menu (in this case Pipe Data) that stores
a parameter (either a numeric entry or an option list selection.
Menu Cell Data The right-hand column shows the current value stored by left-hand column menu cell.
The Pipe Data Menu includes option list items and numeric entries.
Current Selected Menu The highlighted bar at the bottom of the screen shows the name of the menu that you
accessed (e.g., Pipe Data).
To Next Page
Loading...
