Siemens SITRANS F - Page 130

Setup
3.4 Inputs and outputs
FST030
128 Function Manual, 04/2017, A5E35693328-AA
3.4.4.7.10 Device alarms
Description
Device alarms - If one of the selected events appears this affects the status icon, the related
status output, and the alarm on the communication interface.
Setting 148 Transm. temp. above alarm limit; 149 Transm. temp. below alarm limit; 150 Sensor
signal disrupted; 159 Internal error in transmitter
Default
None
Related
Path
Setup → Inputs and outputs → Channel 2 - output → Status output → Device alarms
3.4.4.7.11 Input/output alarms (1)
Description
Selection of alarm items that impact the output. Applicable if Status mode = Alarm item.
Availability of certain settings depends on Hardware and Software configuration.
Setting
195 CH2 loop cur. in lower saturation; 196 CH2 loop cur. in upper saturation; 197 CH2
cable break; 198 CH2 output frequency too low; 199 CH2 output frequency too high; 200
CH2 pulse overflow; 201 CH3 loop cur. in lower saturation; 202 CH3 loop cur. in upper
saturation; 203 CH3 cable break; 204 CH3 output frequency too low; 205 CH3 output fre-
quency too high; 206 CH3 pulse overflow; 207 CH4 loop cur. in lower saturation; 208 CH4
loop cur. in upper saturation; 209 CH
4 cable break; 210 CH4 output frequency too low; 211
CH4 output frequency too high; 212 CH4 pulse overflow; 214 Channel 2 simulated; 215
Channel 3 simulated; 216 Channel 4 simulated; 217 Process values frozen; 218 All outputs
forced; 219 CH2 loop current deviation; 220 CH3 loop current deviation; 221 CH4 loop
current deviation; 222 Invalid register mapping; 223 Invalid coil configuration
Default
None
Related
Path
Setup → Inputs and outputs → Channel 2 - output → Status output → Input/output alarms (1)
3.4.4.7.12 Input/output alarms (2)
Description
Input/output alarms (2)
Setting
186 CH3 input current too low; 187 CH3 input current too high; 188 CH3 external failure;
189 CH4 input current too low; 190 CH4 input current too high; 191 CH4 external failure
Default
None