Siemens SITRANS F - Totalizer Alarms; Device Alarms; Channel 1 Alarms

Setup
3.4 Inputs and outputs
FST030
Function Manual, 04/2017, A5E35693328-AA
195
3.4.8.9
Totalizer alarms
Description
Selection of alarm items that impact the output. Applicable if Status mode = Alarm item.
For hydrocarbon and gas applications only.
Setting
136 Totalizer 1 above alarm limit; 137 Totalizer 1 above warning limit; 138 Totalizer 1 -
below warning limit; 139 Totalizer 1 below alarm limit; 140 Totalizer 2 above alarm limit;
141 Totalizer 2 above warning limit; 142 Totalizer 2 below warning limit; 143 Totalizer 2
below alarm limit; 144 Totalizer 3 above alarm limit; 145 Totalizer 3 above warning limit;
146 Totalizer 3 below warning limit; 147 Totalizer 3 below alarm limit
Default
None
Related
Path
Setup → Inputs and outputs → Channel 4 - relay → Totalizer alarms
3.4.8.10
Device alarms
Description
Device alarms - If one of the selected events appears this affects the status icon, the related
status output, and the alarm on the communication interface.
Setting
148 Transm. temp. above alarm limit; 149 Transm. temp. below alarm limit; 150 Sensor
signal disrupted; 159 Internal error in transmitter
Default
None
Related
Path
Setup → Inputs and outputs → Channel 4 - relay → Device alarms
3.4.8.11
Channel 1 alarms
Description
Channel 1 alarms - The output is active when one of the alarm items occurs.
Setting
153 CH1 loop cur. in lower saturation; 154 CH1 loop cur. in upper saturation; 155 CH1 loop
current deviation; 158 CH1 cable break
Default
None
Related
Path
Setup → Inputs and outputs → Channel 4 - relay → Channel 1 alarms