Siemens SITRANS F - Sensor Events (2); Process Events (1)

Maintenance and diagnostics
4.2 Diagnostic events
FST030
246 Function Manual, 04/2017, A5E35693328-AA
Related
The selected events will be shown in the display when they occur. Furthermore, they will be
indicated on the output if
Output (2)
,
Input/output (3)
and/or
Input/output (4)
is set to Status
output and
Status mode
is set to Alarm item.
Path
Maintenance and diagnostics → Diagnostic events → Enable alarms → Sensor events (1)
4.2.7.2
Sensor events (2)
Description
Various sensor alarms can be enabled to show in the display and on the output if they occur.
Setting 32 Auxiliary input; 33 DSL SIL; 34 Invalid flow meas.; 35 Failure on CH5 or CH6; 36 Con-
figuration 2; 37 DSL system monitor
Default
-
Related
The selected events will be shown in the display when they occur. Furthermore, they will be
indicated on the output if
Output (2)
,
Input/output (3)
and/or
Input/output (4)
is set to Status
output and
Status mode
is set to Alarm item.
Path
Maintenance and diagnostics → Diagnostic events → Enable alarms → Sensor events (2)
4.2.7.3
Process events (1)
Description
Various sensor alarms can be enabled to show in the display and on the output if they occur.
Setting
228 Sound velocity above alarm limit; 229 Sound velocity above warning limit; 230 Sound
velocity below warning limit; 231 Sound velocity below alarm limit; 232 Flow velocity above
alarm limit; 233 Flow velocity above warning limit; 234 Flow velocity below warning limit;
235 Flow velocity below alarm limit; 236 Pressure above alarm limit; 237 Pressure above
warning limit; 238 Pressure below warning limit; 239 Pressure below alarm limit; 244 Kin.
viscosity above alarm limit; 245 Kin. viscosity above warning limit; 246 Kin. viscosity below
warning limit; 247 Kin. viscosity below alarm limit
Default
Related
The selected events will be shown in the display when they occur. Furthermore, they will be
indicated on the output if
Output (2)
,
Input/output (3)
and/or
Input/output (4)
is set to Status
output and
Status mode
is set to Alarm item.
Path
Maintenance and diagnostics → Diagnostic events → Enable alarms → Process events (1)