Siemens SITRANS F - Page 269

Maintenance and diagnostics
4.4 Diagnostics
FST030
Function Manual, 04/2017, A5E35693328-AA
267
Related
In this parameter the setting of
Operation mode
is read only.
Path Maintenance and diagnostics → Diagnostics → Inputs and outputs → Channel 2 - output →
Operation mode
4.4.3.2.2 Totalized amount
Description
The actual totalized amount.
Options Actual totalized amount
Default
-
Related
Path
Maintenance and diagnostics → Diagnostics → Inputs and outputs → Channel 2 - output →
Totalized amount
4.4.3.2.3 Channel value (read only)
Description
The channel value can be viewed in this parameter.
Related
if
Operation mode
is set to Current output, this parameter will show the current output value.
if
Operation mode
is set to Frequency output, this parameter will show the frequency output
value.
if
Operation mode
is set to Pulse output, this parameter will show the pulse output value.
if
Operation mode
is set to Status output, this parameter will show the status output value.
Path
Maintenance & diagnostics → Diagnostics → Inputs and outputs → Channel 2 - output →
Channel value
4.4.3.2.4 Error status (read only)
Description
The error status of the channel can be viewed in this parameter.
Options
Overflow; Underflow; Fail--safe behaviour active; Cable break; Loop current deviation -
Output current cannot be established (read back deviation > 0.1 mA)
Operation mode is set to Current output