Siemens SITRANS F - Channel 2 - Output

Maintenance and diagnostics
4.8 Simulation
FST030
286 Function Manual, 04/2017, A5E35693328-AA
Setting
3.5 mA to 25 mA
Default
4.00 mA
Related
This parameter is only available if
Simulation
is enabled.
Path
Maintenance and diagnostics → Simulation → Simulation inputs and outputs → Channel 1 -
output with HART → Simulation value
4.8.1.2
Channel 2 - output
4.8.1.2.1 Operation mode
Description
Set the output functionality you want the channel to operate.
Setting
Off; Current output; Frequency output; Pulse output; Status output
Default
Off
Related
The setting of this parameter affects the setting options in parameter
Simulation value.
Path
Maintenance and diagnostics → Simulation → Simulation inputs and outputs → Channel 2 -
output → Operation mode
4.8.1.2.2 Simulation
Description
Enables or disables simulation of channel 2 current output.
Setting
Disabled; Enabled
Default
Disabled
Related
Only if this parameter is set to Enabled, then the setting of parameter
Simulation value
will
be relevant.
Path
Maintenance and diagnostics → Simulation → Simulation inputs and outputs → Channel 2 -
output → Simulation