Siemens SITRANS F - Slave Address (HW) (Read Only); Baud Rate; Parity; Framing

Communication
5.3 Modbus (Channel 1)
FST030
Function Manual, 04/2017, A5E35693328-AA
321
Setting
1 to 247
Default
Related
Path
Communication → Modbus (Channel 1) → Slave address (SW)
5.3.2
Slave address (HW) (read only)
Description
The slave address (HW is determined by the DIP switch setting on the transmitter cassette
and can be read out in this parameter. This address is used if the DIP switch is set to a value
> 0.
Options
Read only
Related
Path
Communication → Modbus (Channel 1) → Slave address (HW)
5.3.3
Baud rate
Description
Baud rate of Modbus interface.
Setting
9600 Bit/s; 19200 Bit/s; 115200 Bit/s; 38400 Bit/s; 57600 Bit/s; 76800 Bit/s; 1200 Bit/s;
2400 Bit/s; 4800 Bit/s
Default
Related
Path
Communication → Modbus (Channel 1) → Baudrate
5.3.4
Parity / framing
Description
Parity and framing of the Modbus communication interface.
Setting
Even parity, 1 stop; Odd parity, 1 stop; No parity, 2 stop
Default