Siemens SITRANS F - Decimal Places; Alarm and Warning Limits

Setup
3.2 Process values
FST030
Function Manual, 04/2017, A5E35693328-AA
65
Read only.
Setting
m
2
/s (square meters per second); cSt (1 centistoke = 1 mm
2
/s); St (stokes, 1St = 1cm
2
/s)
Default
m
2
/s (square meters per second)
Related
Path
Setup → Process values → Kinematic viscosity→ Units
3.2.8.2
Decimal places
Description
Sets the decimal places for the process value displayed in the local display.
Setting
Auto; No decimal place; 1 decimal place; 2 decimal places; 3 decimal places; 4 decimal
places; 5 decimal places; 6 decimal places
Default
2 decimal places
Related
Path Setup → Process values → Kinematic viscosity → Decimal places
3.2.8.3
Alarm and warning limits
3.2.8.3.1 Upper alarm limit
Description
If process value exceeds this limit an alarm is triggered.
Setting
-9999997952 m²/s to +9999997952 m²/s
Default
+9999997952 m²/s
Related
Path
Setup → Process values → Standard kinematic viscosity → Alarm and warning limits → Up-
per alarm limit
3.2.8.3.2 Upper warning limit
Description
If process value exceeds this limit a warning is triggered.
Setting
-9999997952 m²/s to +9999997952 m²/s
Default
+9999997952 m²/s