● Empty tube monitoring
● Simulation of process values
● Simulation of outputs
● Simulation of diagnostics
● Enabling alarms for visibility on all outputs (HMI, status and communication)
● Comprehensive diagnostics (NAMUR or Siemens standard) for troubleshooting and sensor
checking
● Firmware update
● Use in hazardous areas according to specification
● USB mass storage* (not available in the USA)
● Data logging of process values and parameter value change in SensorFlash
● Peak indicators - logging of min & max process peak values with time stamp information
● Alarm delay
● Damping filtering system for process values at HMI or outputs
● Spare part replacement
● Selection of active or passive output signals in non-hazardous areas
● Intelligent filtering system for aerated flow
Description
3.5 Features
SITRANS FC330
34 Operating Instructions, 01/2019, A5E44030648-AB
To Next Page
Loading...
