Select zero point adjust‐
ment method
Auto, Manual
Configure Configure duration and limits
Auto zero point adjustment Cancel, Start (progress, result, standard deviation and offset)
In progress The progress bar is shown
Result Information on success or failure of zero point adjustment
View result Standard Deviation and Offset values
*: Selecting Cancel will bypass the Zero point adjustment and end the wizard.
Note
View result
Standard deviation and Offset values are only updated if the zero point adjustment was
completed successfully. Otherwise the previous values are used.
Commissioning
6.3 Local commissioning via HMI
SITRANS FC330
Operating Instructions, 01/2019, A5E44030648-AB 91
To Next Page
Loading...
