Siemens SITRANS FS230 - Page 50

Perform the following steps for each current input cable.
1. Remove cap and ferrule from cable gland and slide onto cable.
2. Remove one of the blind plugs (① or ②) and 󹪝t cable gland.
FS0025.01






$
3. Push cable through gland opening.
4. Ground current input cable shield using the ground clamp inside the external DSL.
5. Connect the two wires to two-terminal block (Ch5+ and Ch5-, or Ch6+ and Ch6-).
&K
&K
&K57'
&K57'
',3
&K &K
&K &K
,VRXUFH 9VHQVH 9VHQVH ,VRXUFH
,VRXUFH 9VHQVH 9VHQVH ,VRXUFH
5666/ 5666/ 7(50 7(50
9'& 9'& % $
66/
6. Assemble and tighten cable gland.
Connecting RTD cable
Perform the following steps for each RTD cable.
1. Remove cap and ferrule from cable gland and slide onto cable.
2. Remove one of the blind plugs (① or ②) and 󹪝t cable gland.
FS0025.01






$
3. Push cable through gland opening.
Connecting
4.5Connecting the external DSL
SITRANS FS130 & FS230
50 Compact Operating Instructions, 12/2023, A5E38755607-AF