Siemens SITRANS FS230 - Connecting industrial enclosure; Preparing industrial enclosure connections

4.6 Connecting industrial enclosure
4.6.1 Preparing industrial enclosure connections
WARNING
Access to terminal compartment
As long as the device is energized, the lid of the enclosure on the sensor connection area may
only be opened by quali󹪝ed personnel.
Before removing the terminal cover, the auxiliary power must be switched o󹪜 from all poles.
Following installation, the terminal cover must be screwed back on again.
1. Remove blind plugs where required and mount cable glands.
2
3
1
① Input/output connection (channels 2 to 4)
② Power supply connection
③ Current output/communication outputs (channel 1)
2. Remove lid lock screw for terminal connections lid.
3. Remove lid for terminal connections.
A label showing the con󹪝guration is placed at the back of the terminal connections lid.
Connecting
4.6Connecting industrial enclosure
SITRANS FS130 & FS230
Compact Operating Instructions, 12/2023, A5E38755607-AF 55