Connecting
5.4 Sensor wiring
FSS200 clamp-on sensors
52 Installation Manual, 08/2017, A5E36255466-AC
Prepare unterminated cable ends as follows:
1. Strip unterminated outer jacket
③, outer shield ④, and inner jacket ⑤ to shown lengths
(mm/in).
2. Trim exposed inner shield
⑥ to shown length (mm/in).
3. Fold back exposed inner shield
⑥ over inner jacket ⑤ and trim dielectric ⑦ and center
conductor
⑧ to shown lengths (mm/in).
To Next Page
Loading...
