Siemens SITRANS FST030 - Page 353

Channel 3, 309
Channel 3 analog intput settings, 237
Channel 3 current output settings, 217
Channel 3 discrete input settings, 235
Channel 3 discrete input signal, 322
Channel 3 frequency output settings, 224
Channel 3 input current, 322
Channel 3 output current, 321
Channel 3 output frequency, 321
Channel 3 output pulse, 322
Channel 3 output status, 321
Channel 3 pulse output settings, 231
Channel 3 status output settings, 233, 256
Channel 4, 310
Channel 4 analog intput settings, 260
Channel 4 current output settings, 241
Channel 4 discrete input settings, 258
Channel 4 discrete input signal, 324
Channel 4 frequency output settings, 248
Channel 4 input current, 324
Channel 4 output current, 323
Channel 4 output frequency, 323
Channel 4 output pulse, 324
Channel 4 output status, 323
Channel 4 pulse output settings, 254
Channel 5 RTD configuration settings, 266
Channel 6 RTD configuration settings, 266
Coil configuration, 135
Common channel 5 and 6 RTD configuration
settings, 263
Data logging, 318
Density settings, 187
Device reset, 332
Diagnostic log, 291
DSL error codes, 305
DSL temperature, 306
Enable events, 289
Float byte order, 138
Flow velocity settings, 185
FW update change log, 331
General, 307
General channel 2 settings, 199
General channel 3 settings, 216
General channel 4 settings, 240
General Modbus settings, 133, 138
General path settings, 168
General pipe settings, 160
General sensor settings, 160
General settings, 267, 268
I/O cassette, 285
Integer byte order, 138
IO values, 143
Kinematic viscosity settings, 188
Limit monitoring (for path diagnostic alarms), 182
Liquident settings, 186
Local display, 285
Maintenance & diagnostics, 283
Mass flow settings, 183
Medium temperature, 305
Medium temperature settings, 190
Modbus register mapping, 137
Multipoint calibration, 176
Oil table settings, 333
Operating time, 329
Parameter change log, 330
Path 1 diagnostics, 300
Path 1 settings, 170
Path 2 diagnostics, 301
Path 2 settings, 170
Path 3 diagnostics, 302
Path 3 settings, 171
Path 4 diagnostics, 303
Path 4 settings, 172
Pressure settings, 189
Process medium characteristics, 164
Process value 1, 312
Process value 2, 313
Process value 3, 314
Process value 4, 315
Process value filter masks, 282
Process values for standard applications, 141
Product, 316
Rate of change (ROC) settings, 193
Scraper pig detection settings, 335
Selectable values dependent on the view
type, 279
Sensor, 286
Sensor cassette, 286
Sensor diagnostics, 300
Sensor frontend, 316
SensorFlash, 317
Service channel, 336
Simulate alarms, 327
SITRANS FS230, 283
Sound velocity settings, 186
Specific gravity settings, 192
Standard API gravity settings, 191
Standard specific gravity settings, 192
Standard viscosity settings, 189
Standard volume flow settings, 184
Supported events, 288
Totalizer 1 settings, 193
Totalizer 2 settings, 195
Totalizer 3 settings, 197
Index
SITRANS FST030 (Modbus)
Operating Instructions, 08/2018, A5E37367739-AD 353