6.3 Power up
Power up the device. Devices with local display show a screen for initial startup.
See also
Initial startup (Page 53)
6.4 Local display
The device is commissioned/operated with the touch keypad on the local display.
The elements are actuated by touching the glass panel on the appropriate key. Pressing harder
will not activate the key, but using a thumb instead of a finger tip will help. The text display above
the operating elements gives a menu-guided operation of the individual device function/
parameters. Successful operation of the key is confirmed by a small green LED at the right of
the display.
① Full graphical display
② LED (for indication of key operation)
③ Touch keypad
Figure 6-1 Local display
Note
(Re-)calibration of the keypad
When the lid is closed, all keys are (re-)calibrated (< 5 seconds). During (re-)calibration the LED
is on and the keys cannot be operated.
If one of the keys is pressed for more than 10 seconds, the (re-)calibration of this key begins
which has a duration of less than 10 seconds. Release the key for further operation.
Note
HMI timeout
If no key is pressed for 10 minutes, the display switches to show operation view. If Backlight is
set to Automatic, display backlight goes off automatically 30 seconds after the last keypress.
Commissioning
6.4 Local display
SITRANS FST030 (Modbus)
52 Operating Instructions, 08/2018, A5E37367739-AD
To Next Page
Loading...
