Sensor settings (5)
Path settings
No
Yes
Installed paths
Save settings
Start measurement
Mounting path 1
Path 1
Path geometry
*
**
Finished
Text Options/Description
Path settings Select "YES" to configure the path(s).
Installed paths Select the paths installed.
Save settings Moves to the next menu item.
Start measurement * for each installed path. Select the path to configure.
Path geometry Define the geometry of the path (direct or reflect mode)
Mounting path 1 Represents the spacing offset. Use Nom for most applications.
Path 1 Select "Receiver signal" to view graphical display of the receiver signal.
** Select "Next" to configure next path or to select "Next" to finish the
wizard.
6.6.1.3 Process values wizard
The Process values wizard will guide you through setup of process values for your application.
The prioritizing of the process values automatically configures the measurement views on the
display. The process value configured as first process value is set as first display view.
Commissioning
6.6 Commissioning via local display
SITRANS FST030 (Modbus)
60 Operating Instructions, 08/2018, A5E37367739-AD
To Next Page
Loading...
