Introduction
1
These instructions contain all information required to commission and use the device. Read the
instructions carefully prior to installation and commissioning. In order to use the device
correctly, first review its principle of operation.
The instructions are aimed at persons mechanically installing the device, connecting it
electronically, configuring the parameters and commissioning it, as well as service and
maintenance engineers.
1.1 Document History
The following table shows the most important changes in the documentation compared to each
previous edition.
Edition Remarks FW version EDD version
05/2018
● Restructure this document
● Updates in transmitter and sensor
connection
● Adding current output option module
● Adding Accuracy to Technical Data
● Responsibility transfer to Siemens AG
2.04 1.02.09
09/2016
● Restructure this document
● Updates for SIMATIC PDM 8.2
2.03 1.02.08-01
09/2013
● Restructure this document
● Adding transmitter information
2.03 1.02.07
09/2011 Update with FW 2.03 2.03 1.02.07
10/2010 Update with FW 1.05 1.05 1.01.04
12/2009 Update with FW 1.04 1.04 1.01.04
2003 First edition with product release 1.02 1.01.04
The FUS080 is configured in a combination of hardware (HW) and firmware (FW). For
communication and parametrization via SIMATIC PDM the correct version of the EDD driver for
FUS/FUE 380 is needed. The various relations are listed above.
1.2 Items supplied
The device can be delivered as either a compact or a remote system.
SITRANS FUS380/FUE380
Operating Instructions, 05/2018, A5E00730100-AE 7
To Next Page
Loading...
