OPERATION 6
77
SITRANS FX330
www.siemens.com/flow08/2022 - A5E36751269-AG EN
A11.4 Application Assistant - Heat Measurement
.5.2 Temp. Source2 Internal / External / External HART / Not Available
Temperature source 1 and 2 must be different.
.6 Operating Values Same options as in A11.1.4.
.7 Current Output Same options as in A11.1.5.
.8 Binary Output Same options as in A11.1.6.
.9 Pulse Output Same options as in A11.1.7.
.10 Frequency Output Same options as in A11.1.8.
.11 Status Output Same options as in A11.1.9.
.12 Limit Switch Same options as in A11.1.10.
.13 Flow Totalizer Same options as in A11.1.11.
.14 Energy Totalizer Same options as in A11.1.12.
.15 1. Meas. Page Same options as in A11.1.13.
.16 2. Meas. Page Same options as in A11.1.14.
Table 6-24: A11.3 Application Assistant - Superheated Steam
Function Setting / Description
This application assistant is available if meter type is not set to "Standard" (refer to "C6.3 Extras").
.1
.2 Units
.2.1 Volume Flow
Select unit (default: according to order specification or m
3
/h).
.2.2 Mass Flow Select unit (default: according to order specification or kg/h).
.2.3 Power Select unit (default: according to order specification or kJ/h).
.2.4 Volume
Select unit (default: according to order specification or m
3
).
.2.5 Mass Select unit (default: according to order specification or kg).
.2.6 Energy Select unit (default: according to order specification or kJ).
.2.7 Temperature Select unit (default: according to order specification or °C).
.2.8 Pressure Select unit (default: according to order specification or bar).
.2.9 Density
Select unit (default: according to order specification or kg/m
3
).
.3 Process
.3.1 Fluid Select "Steam" or "Liquid".
.3.2 Medium Select "Saturated Steam", "Superheated Steam" or "Water".
.3.3 Time Constant 0...100 s
.3.4 Low Flow Cutoff Enter low flow cutoff point in current volume flow unit.
.4 Current Input
.4.1 Function Select "On".
.4.2 Current Input Meas. Select "Temperature External".
.5 Temp. Sensor
.5.1 Temp. Source1 Internal / External / External HART / Not Available
.5.2 Temp. Source2 Internal / External / External HART / Not Available
Temperature source 1 and 2 must be different.
.6 Operating Values Same options as in A11.1.4.
.7 Current Output
Function Setting / Description
To Next Page
Loading...
